C-TEMP (Light-Medium-Bleach)
C-TEMP (Light-Medium-Bleach)
- Biocompatible, MDR-compliant material
- Exceptional breakeage and high wear resistance
- Flexural strength 126 MPa standard ASTM D790-02
- Produced under ISO standards 13485:2016
- Find here validated 3D printers list
Please find post processing and instructions for use here.
*Disclaimer: All European customers please add your valid VAT number during check out! Check here how to add VAT
Product Description
Product Features
- Exceptional breakeage and high wear resistance
- Flexural strenght 126 MPa standard ASTM D790-02
- Produced under ISO standarts 13485:2016
- Find here validated 3D printers list
Material Properties
Material PropertiesValueStandardTensile strength66.5 MpaASTM D638Flexural strength126 MpaASTM D790-02Flexural modulus2980 MpaASTM D790-02Shore Hardness85.7ASTM D2240Density1.14 g/cm3 at 23 CASTM D1475Viscosity2500-3000 mPa.s at 23 CDIN 53211-4ColorAçık(A1-B1) Orta(A2-A3) Bleach (BL1)
Post Process
1- Washing
After the printing is completed, wash the part as attached to the building plate with ethyl alcohol (>%90) or isopropyl alcohol (>%90) for 5 minutes. Make sure that alcohol covers the part entirely when washing. Since the Temp resin is biocompatible never wash it with the alcohol used for other resins before. Use a brush to remove uncured resin if needed. Do not over-wash, it may cause deterioration in dimensions of the part.
2- Drying
Use air-compressor to dry the washed part. Make sure that the part is dry and uncured resin is cleaned up completely. If there is still uncured resin left on the part, wash it with fresh alcohol and dry again.
3- Part Removal
Remove the printed part from the build plate using a scraping tool. Be very careful not to damage the model.
4- Post Curing 20 minutes with MEDIFIVE curing chamber at 3rd-degree light intensity Otoflash curing recommendations 126 MPa flexural strength with 10000 flashes without gas. For the multiunit implant applications if you would like to reach the PMMA level, we recommend curing with gas(nitrogen, argon). After the post curing, supports should be removed from the model cautiously and then desired sandblasting and polishing can be done.
Storage Conditions
Store the PowerResins Temp bottle in dark and moisture free place at room temperature (20-24 °C).
Do not forget shaking the resin well before use.
If your printer has heater, you can set the temperature at 32 °C. Otherwise, you can heat your resin in a microwave for 18 seconds or by submerging in hot water for 15-20 minutes.
-
HIGH WEAR RESISTANCE
Thanks to the technical properties that having stain free abrasion resistant formulation.
-
CONSISTENT SHADES
Having consistent shades available A1, A2, Bleach.
-
LOW SHRINKAGE
PowerResins Temp having less shrinkage and not changing the shape after post processing.
-
BIOCOMPATIBLE
Certified biocompatible Temporary crown resin and safe to use in patient's mouth.