SMOOTH SURFACE

Specially made for direct casting. Evaporates with heat leaving no ash.

LOW SHRINKAGE

Easy to cast with investments such as Sherafine, Polyvest, Siladent, Bego, Nanovest or others

SAFE & NOT SMELLY

Suitable for Emax press using any investment

COMPATIBLE WITH 365,385 and 405 nm

You can use this resin with any printer that has 365-385nm or 405nm light source

ACCURATE

Provide high accuracy print suitable for models with dyes

Quadrant Mouth Model

Models with Dies

Model with Surgical Guide

Inlay Application: Mouth Model

Model with Temporary Tooth

Parsial Application: Mouth Model

Model Resin Storage Conditions and Post Processing 

Store the PowerResins Model bottle in dark and moisture free place at room temperature (20-24 °C). Do not forget shaking the resin well before use. If your printer has heater, you can set the temperature at 32 °C. Optionally, you can heat up your resin in a microwave for 18 seconds or by submerging in hot water for 15-20 minutes.

Post Processing Steps 

- Remove the printed part from the building plate using a scraping tool.
- Be very careful not to damage the model.

4- Post Curing

- You can reach 99 MPa flexural strength within 20 minutes with general UV curing.
- With a professional curing machine like Otoflash you can reach;
69 MPa flexural strength with 5000 flashes,
71 MPa flexural strength with 10000 flashes without gas.
- After the post curing, supports should be removed from the model cautiously and then desired sandblasting and polishing can be done

Do you have a Sticking Problem on your Build platform?

Solution :

Primer Resin Strong Adhesion

PowerResins Primer, is a resin that has very strong adhesion properties and designed to use for any LCD, DLP and SLA technology printers who has adhesion issues with.