Elegoo Mars 3D Printer Settings

You can use PowerCast Burn DLP resin with Elegoo Mars 3D Printers. You simply need to adjust the printing profiles.

We provide here print settings, however you can adjust these parameters according to the type of print you are making or the Z layer thickness you wish to use.

Settings for 50 micron with PowerCast Burn resin

Below we share the settings that our customers are using for 50 micron with PowerCast Burn DLP  castable resin.

 Layer Height :  0.05
Bottom Count : 8
Exposure Time :  14s
Bottom Exposure : 80s
Light Off :  0s
Bottom Light Off : 0s

You may adjust the Z layers height depending on your need. As a typical rule of thumb, if you decrease the Z layer height, we would decrease the Exposure time, while if you increase the Z layer height, you would increase the exposure time.

Please see below some prints and casting results from VOG youtube channel you can watch more about printing and casting tips also from the link below;

https://www.youtube.com/watch?v=eDl3vzZy0qQ&t=207s 

Many thanks to Geoff Adams for sharing his experience with us !