Stone-In-Place Casting for High-End Jewelry

You will find below a helpful article about the in stone casting process as well as which stones are suitable for stone casting or not and why? Introduction  Not all types of stones are suited for an in stone place casting method- Diamonds excepted , stone minerals are not good conductors of heat, they can suffer shock during rapid heat or cool...
Continue reading

Phrozen Sonic Mini Printer Printer Setting

Please find below printing settings at 50 micron for Powerresins Dark resin;Please note that these settings are provided by customers who are using our resins with Phrozen Sonic Mini 3D printers so that may cause discrepancies. Dark Resin settings Layer Height  0.05 mm Bottom layer count 8 Exposure time 17 second Bottom exposure 110 ...
Continue reading

Prusa 3D Printers Settings

You can use Opague, Dark, Zero and Wax DLP resins with Prusa SL1 3D Printer. Find below printing settings at 50 micron for this resins;Please note that these settings are provided by customers who are using our resins with Pruse SL1 3D printers so that may cause discrepancies. Thick Model Settings; Opaque Resin Exposure 15 seconds In...
Continue reading

Difference Between Castable Resins for Jewelry

Is it hard to decide which castable resin  I need to choose for a specific applications(surface, stone setting, filigree, cast in stone) or due to technology? We have all the answers below to make your choice easier. First of all, the main common specifics  for our castable resins that you do not need any post curing after print!  If you would ...
Continue reading

Octave Light Printer Setting for jewelry and Dental

Please find below printing settings at 50 micron for PowerCast Burn and PowerCast Opaque resins; Please note that these settings are  provided by customers who are using our resins with Octave Light printers so that may cause discrepancies.   Adjust Resin Depth Speed(um/s): 75 Burn-in Exposure Time(ms): 15000 Dip Depth(um): 4000 Dip Retraction S...
Continue reading

PowerDent Temp profile settings for Anycubic Photon 3D Printer

We will provide some profiles for PowerDent Temp DLP resin, however you can adjust these parameters according to the type of print you are making or the Z layer thickness you wish to use. Settings for 50 micron with PowerDent Temp resin Below we share the setting that our customers are using for 50 micron with PowerDent Temp resin. Slice Sett...
Continue reading