PowerCast Burn profile settings for Anycubic Photon 3D Printer

You can use any of our DLP resins with Anycubic Photon 3D Printers. Most particularly if you are looking for direct castable resin, we can recommend PowerCast Burn and PowerCast Wax resins. You simply need to adjust the printing profiles.

We will provide some profiles for PowerCast Burn DLP resin, however you can adjust these parameters according to the type of print you are making or the Z layer thickness you wish to use.

Settings for 35 micron with PowerCast Burn resin

Below we share the setting that our customers are using for 35 micron with PowerCast Burn castable resin.

Layer Tickness(mm) 0.035
Normal exposure time (s) 14
Off time (s) 1
Bottom exposure time (s) 80
Bottom layers 8

 

If you wish to use PowerCast Wax at 35 micron Z layer, you may simply change the Normal exposure time (s) to a value of 8 seconds. PowerCast Wax is a faster curing resin than PowerCast Burn and you may want to adjust the curing time according to the type of jewelry or product you wish to print.